Page 1    Page 2
Page 2 of 2
DASH GAUGE PLATE Instructions

 

  1. Peel red liner from the backside and slowly and carefully re-position the Dash Control Panel Overlay into place.
    NOTE: YOU ONLY HAVE ONE SHOT AT THE FINAL PLACEMENT so you may want to make a couple dry runs before actually mounting the trim plate. 
    Once you stick it on - it is permanent.

 

  1. Once you have successfully mounted it into position, press firmly over the entire plate to set.  Take masking tape and tape up the outer edges of the entire Dash Control Panel Overlay.  This will firmly hold it in place until the adhesive is set.  Allow to set this way for at least 8 hours.  DO NOT GET WET FOR 24 HOURS.

 

  1. After this time period is over peel off all the masking tape.  Peel off the clear protective liner on the front of the Dash Plate.  Clean off all adhesive residues from tape.

 

If any questions occur during installation please contact us at:
 admin@TheViperStore.com
 

CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it.
Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

 


           

 


2006-2012 copyright
TheViperStore.com is a HotCarAccessories site