Dodge Viper SRT/10 (2003-2006) & 2008
Valve Cover Polished Stainless Steel Letters 10pc
Part#  ACC-V3AL307 and ACC-V3AL307-1
INSTALLATION INSTRUCTIONS 

Items Included:   (1) Stainless Steel Letters -10 total;  (1) Promoter packet
 
Instructions:
1.  You should have pieces that spell out "VIPER" for each Valve Cover.  Ten pieces in all.   

2.  Wash the area on your engine Valve Cover where you are going to mount the letters. 

3.  Set each number on top of Cover to see how it fits. 

4.  Once you are comfortable with how each letter fits take your promoter packet or pen and open it (you must snap the pen at its midpoint to initiate it). 
Wipe down the raised 3-D letters on the Valve Cover where you are doing to mount your new stainless steel letters. 

5.  Let dry for 2 minutes.  Remove the back off one letter at a time and place it on top of the Valve Cover where it goes.  Press firmly all along the surface of the each Letter.
 
6.  If you Letters have a clear plastic protective seal on top of them you may peel it off at this time. 

7.  Let sit over night. 

8.  Clean with a good glass cleaner as needed.
 
If you have any questions during installation please contact us at :admin@TheViperStore.com