Page 2 of 2
Viper Gen2 Etched Trunk Lid Instructions

 

  1. With all modifications completed you may now begin to install the new panel insert. You will notice a “V” shaped inner framework of the deck lid. Scrub this framework with household rubbing alcohol to remove any dirt or surface contaminants. Then swipe the area with the adhesive promoter provided. Once this has been completed place the panel in position and make note of its position and just how you are going to maneuver it in place. Place a large golf ball size blob of silicone to each of the areas between the attachment tape on the panel insert. Once this is done peel the red release liner and carefully place the panel into position and press firmly to set to the prepared framework. Allow the lid to remain vertical for several hours to set.

 

  1. Remove protective liner.


    CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.  


Questions?  Please contact:  admin@TheViperStore.com

 

    
 
TheViperStore.com is a HotCarAccessories.com site a division of emagineit, inc.
Copyright 2005-2008