POLISHED STAINLESS VIPER II HEADLIGHT BUCKETS

PART# ACC-DVHB306

INSTALLATION INSTRUCTIONS

 

NOTE: Your new covers come to you with a clear protective liner.   Do not remove this liner until prompted to in step 3.

 

PARTS INCLUDED:
 2-Stainless Covers

4-1” Chrome Covers

4-Round Furry Cookies

 

  1. Open hood and remove the two screws directly on top of the headlight and set aside.
     
  2. Your new covers come to you pre-formed however it will be necessary for you to adjust its overall shape by hand until you achieve a nice snug contoured fit. This can be done by installing either side to see just where and how it may need to be adjusted to fit. You can do this by forcing the outer side (the smaller section) between the body and the headlight first then force it between the hood hinge and the headlight. The cover is designed to snap into a snug position. Typically the area that may need adjusting is the possible gap between the cover and the most forward part of the headlight. If this gap is apparent simply make note of any and all spaces or gaps then remove the cover and adjust by hand accordingly.
     
  3. Once you have achieved a nice snug contoured fit remove the protective liner and line up the two screw holes and replace the factory screws that you removed in step one. At this point your new cover should nicely wrap the entire upper half of the headlight.

 

  1. The two factory screws that you just set in place in step three will need to be sealed. Simply place a small dab of clear household silicone to the underside of the two 1” chrome covers (provided) for each headlight cover and carefully set over each screw and allow a couple of hours to set or if need be tape in position until silicone dries and remove tape at a later time.
     
  2. You have been provided with four round furry cookies these have been provided for you to place on the factory hinge bracket to prevent any possible scratching in case the hinge comes in contact with your new cover during opening and closing. Repeat steps 1-5 for opposite side.

 

Note: Care must be taken when cleaning your covers. It is a good idea to lightly dust your covers with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

 

If any questions or problems occur during installation, please contact us at admin@theViperStore.com