DODGE VIPER II Side Fender Vent Grilles 2pc
PART ACC-DVGV109 patent pending

INSTALLATION INSTRUCTIONS

 

Your new grille vents come to you with a protective liner. Do not remove liner until installation is complete.

 

ITEMS INCLUDED:

2-Stainless Vent Grilles                                                 2-Rivets and/or 2-screws

2-Adhesive Promoter Packets                                        2-Stainless Brackets

Optional:  An small inexpensive rivet gun.

 

  1. Open the hood completely. You will notice a ridge at the very inside of the hood where the inner structure meets the outer skin. Your new vent grilles are designed to fit directly into this ridge at a diagonal angle.
    In fact, the grille itself will only conform to this area in this way. The first step is to prepare this groove by cleaning away any dirt and grime that may have built up.
    Then scrub the ridge with household rubbing alcohol.

 

  1. Position the grille into this ridge to get a good look at just how it is to be placed. The bottom of the grille should seat at the bottom of the fender lip. Holding the grille in position mark the location of the small hole in the grille to the inner fender wall, then remove the grille. Using a 9/64th drill bit drill a small hole where you just marked.
    NOTE:  Be VERY CAREFUL NOT to POKE the outer skin (painted exterior surface).

 

  1. Once this area has been thoroughly cleaned swipe the area with the adhesive promoter provided.  Next Peel the red release liner from the back of the grille and carefully reposition the grille over the hole you just made and set the grille so that it sticks right into the groove. If done properly the grille should stay in position by itself. At this time rivet the top of the grille using the rivet provided.

 

You have been provided with a stainless bracket which is designed to attach directly to the grille behind the badge over to the hood fender wall. Scrub the two points of attachment with household rubbing alcohol let dry then swipe once with the adhesive promoter provided. Then simply peel and stick the bracket and set into position pressing firmly to both areas to set.

Page 1       Page 2

Page 1 of 2