THE VIPER STORE

This Frame has opened up into a New Window

Dodge Viper Gen III License Plate Frame and Back Plate Assembly ©
Part # V3TB104 patent pending
INSTALLATION INSTRUCTIONS

Included:  1- Chrome License Plate Frame, 4- Chrome plastic nut caps,
1- High Polished Stainless Steel back plate.
Will Need:  4- License plate bolts, small amount of silicone. 

1.  Place your state license plate behind and inside the frame and set aside.
Remove protective liner on the back plate.

2.  Carefully position the back plate (without scratching the paint) inside the license plate well.
Hold it in place while you put the frame with the license plate into position on top of the back plate.

3.  Now hold both pieces in position lining up the two mounting holes at the top of the frame with the holes in the back plate.  Insert your own license plate bolts finger tight on both sides.  Then tighten each side with one turn of the screw driver.  Note:  Tightening too much can damage your parts.

4.  Put a small glob of silicone inside each of the two chrome caps.  Then press the caps on to the top of the bolt heads.  Let dry for one hour.

This Frame has opened up into a New Window