|
This Frame has opened up into
a New Window
DODGE VIPER III VANITY PLATES©
Brushed or Polished
Part # V3VP206 or V3VP207
and patent pending
INSTALLATION INSTRUCTIONS
NOTE: Do not remove your new Vanity Plates protective liner until you
are completely done installing them.
Your new vanity plates are designed to fit just above your door sill
area on the door jam. In order to install simply wipe this area clean first
with soap and water and then with common household Isopropyl Alcohol or
rubbing alcohol found in most grocery stores and all hardware stores.
Let dry then place your new plate into this area and make note of its
position. You will need to slightly bend the Vanity Plate to make it
conform with the slight bend in the inner door where it will go. This is
done by making a slight bend near the center then testing the fit – adjust
as necessary.
Once you are satisfied with the location and the bend you’ve made -
remove the red liner from the attachment tape and reposition. Press firmly
to set.
Repeat
this process for the opposite side.
Note: Care must be taken when cleaning
your new sill s and plates. It is a good idea to lightly dust your plates
with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality
streak free glass cleaner.
 
Note: Vanity Plate installed Note: Before installation of Plate Close
up of installed Vanity Plate
This Frame has opened up into a New Window
TheViperStore.com
a HotCarAccessories.com website a division of emagineit, inc.
2006-2007 copyright
emagineit, inc. |
