VIPER UPGRADE PRODUCTS

This Frame has opened up into a New Window


DODGE VIPER III VANITY PLATES©
Brushed or Polished
Part # V3VP206 or V3VP207 and patent pending
INSTALLATION INSTRUCTIONS

NOTE:  Do not remove your new Vanity Plates protective liner until you are completely done installing them.

Your new vanity plates are designed to fit just above your door sill area on the door jam. In order to install simply wipe this area clean first with soap and water and then with common household Isopropyl Alcohol or rubbing alcohol found in most grocery stores and all hardware stores.

Let dry then place your new plate into this area and make note of its position.  You will need to slightly bend the Vanity Plate to make it conform with the slight bend in the inner door where it will go.  This is done by making a slight bend near the center then testing the fit – adjust as necessary.

Once you are satisfied with the location and the bend you’ve made - remove the red liner from the attachment tape and reposition. Press firmly to set.

Repeat this process for the opposite side.

If any questions occur during installation, please contact:  admin@TheViperStore.com .

Note: Care must be taken when cleaning your new sills and plates. It is a good idea to lightly dust your plates with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

Note: Vanity Plate installed    Note: Before installation of Plate     Close up of installed Vanity Plate

This Frame has opened up into a New Window