|
This Frame has opened up into
a New Window
Dodge Viper Gen III
Stainless Steel
Dash Control Panel Overlay
PART# V3GP210
INSTALLATION INSTRUCTIONS
Included:
Dash Control Panel Overlay, packet of Adhesive Promoter
NOTE:
We recommend that if possible a professional trim, body and paint person
install this part.
VERY IMPORTANT!
First, in order to Allow Adhesion - you must first prepare your Dash area
where the piece is going to be installed. You can do this by scrubbing the
entire area first with household isopropyl alcohol. This will remove all
the built up oils from finger prints, cleaners, shining products, ect.
NOTE:
If this area is not prepared exactly as described above using isopropyl
alcohol installation will NOT work.
We are sorry but we can not be responsible for kits not sticking do to
improper preparation!
NOTE:
Do not take the red backing off your Dash Control Panel Overlay before
instructed to do so in the instructions. Do not take the clear
protective cover off the front of this product until instructed to do so.
-
Scrub your entire are to be mounted first with soap and water, dry the
area. Next clean the entire area thoroughly with household
Isopropyl Alcohol found at any hardware store. Be sure to get
right up to the edges of all gages and bolt holes.
Once complete wipe off all residues.
-
Now you want to work with your Dash Plate to test the fit. Place the
Dash Control Panel Overlay up to the area where it is to be mounted. Slide
around until you are comfortable how it fits. You will only get one shot
at this – so you don’t want to make a mistake.
Your new trim plate comes to you pre-cut, however it will be necessary to
further shape (bend) it by hand in order to achieve a perfect fit without
forcing it. You will have to do this by trial and error. Slightly
bend to follow the contours of the Dash. Once you are satisfied with
its overall fit it is time to move on to Step 3.
-
Swipe the area where the Dash Trim Plate piece will be covering once with
the adhesive promoter (provided). Be sure to carefully apply closely
around any openings and all gage and bolt holes. Be sure to
thoroughly cover all corners.
-
Peel red liner from the backside and slowly and carefully re-position the
Dash Control Panel Overlay into place.
NOTE: YOU ONLY HAVE ONE SHOT AT THE FINAL PLACEMENT so you may want
to make a couple dry runs before actually mounting the trim plate.
Once you stick it on - it is permanent.
-
Once you have successfully mounted it into position, press firmly over the
entire plate to set. Take masking tape and tape up the outer edges of the
entire Dash Control Panel Overlay. This will firmly hold it in place
until the adhesive is set. Allow to set this way for at least 8
hours. DO NOT GET WET FOR 24 HOURS.
After this time period
is over peel off all the masking tape. Peel off the clear protective
liner on the front of the Dash Plate. Clean off all adhesive residues
from tape
This Frame has opened up into a New Window
TheViperStore.com a HotCarAccessories.com website a division of emagineit,
inc.
2006-2007 copyright emagineit, inc. |
