THE VIPER STORE

This Frame has opened up into a New Window

DODGE VIPER III FENDER VENT COVERS
PART #V3SV109 patent pending
INSTALLATION INSTRUCTIONS

NOTE:  Your new covers come to you with a protective liner. Do not remove liner installation is complete. 

1.  Clean all four (4) Mat Black Vent Steps including the very bottom of the opening.  Use a damp cloth to remove any road grime and dirt.  Then scrub these areas with a household rubbing alcohol and re-wipe down with a damp cloth. 

2.  Each vent step Cover has been marked Drive Side 1, 2, 3, or 4 and Passenger Side 1, 2, 3, or 4.  Before you permanently install your new covers take a minute to place each one on its’ corresponding vent step to see how it will fit.  This is your trial run. You can get a feel of how each piece will fit and to make sure you have every piece and it fits.
You find that each cover will have to be manipulated into each cavity at a slight angle to tuck it into the fender space between the vent steps. 
This will give you the clearance necessary to lay the cover down and over each vent step.  Once you aquatinted yourself with the knowledge of how each step cover is to be set in place you may begin the installation. 

3.  You have been provided with two adhesive promoter packets.  Use one of them and swipe the areas where the steps will rest on that you just cleaned.

PLEASE NOTE THAT ONCE YOUR COVERS HAVE BEEN STUCK INTO PLACE THEY CANNOT BE REMOVED WITHOUT DAMAGING THEM. Conduct a test fit of each piece before you peel off the back to expose the adhesive.

4.  Remove the red plastic liner from the #4 Cover (the Bottom Plate) and place it into position.  Press down firmly once it is in place.  Then work your way up to the top cover one piece at a time.  Be sure to test the fit of each piece before you stick it on permanently.

5.  Follow the same procedure on the other side of the car until all vent steps are firmly in place.

     
This Frame has opened up into a New Window

TheViperStore.com a HotCarAccessories.com website a division of emagineit, inc.
2006-2007 copyright emagineit, inc.