THE VIPER STORE

This Frame has opened up into a New Window

POLISHED STAINLESS HOOD SCOOP TRIM PLATE 
PART# DVHS108
INSTALLATION INSTRUCTIONS 

Included:  Hood Scoop Trim Plate, packet of Adhesive Promoter

Do not install this part without reading all the instructions first.
Do not remove clear protective liner until installation is complete! 

1.  Scrub your entire are to be mounted first with soap and water, dry the area and then clean the area with household isopropyl alcohol found at any hardware store. Wipe off any and all residue.

2.  Your new trim plate comes to you pre-shaped, however it will be necessary to further shape (bend) it by hand in order to achieve a nice flat fit without forcing. Once you are satisfied with its overall fit and contour to the hood, make note or mark its position with a grease pencil.

3.  Swipe the area where the trim piece will be covering once with the adhesive promoter (provided).

4.  Peel red liner from the underside and slowly and carefully re-position the plate into place. NOTE: YOU ONLY HAVE ONE SHOT AT THE FINAL PLACEMENT so you may want to make a couple dry runs before actually mounting this part.  IMPORTANT: Once you stick it on it is permanent! 

5.  Once you have successfully mounted it into position, press firmly over the entire plate to set then remove the protective liner.
DO NOT GET WET FOR 24 HOURS. 

CARE AND MAINTENANCE:
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

This Frame has opened up into a New Window